User's Manual




LT‐D‐0211rev16

Page|19


Relays 8Xnormallyopenrelaycontacts.250VAC/5Aeach
Inputs 8Xlowlevelsignalanalog/digitalinputs
Outputs 8Xgeneraluseoutputs,V=24VImax=20mAforeach
LEDs 12XLEDs
Memory 
EEPROM 128MB
Flash 128MB
Environmental 
Operationaltemperature‐10°C÷+45°C
Storagetemperature‐20°C÷+70°C
Dimensionsandweight 
Dimensions LXWXH‐275X159X57mm
Weight 1.29Kg

LFAntennaspowersettings:
ForeachLFantennayoucanconfigureviasoftware,theoutputpoweratrangeofbetween10to100%.

Backupbatteryreplacements:

Warnings:
6. In any case before replacing advice your local supplier technical support or Logitag customers
support.
7. Onlyauthorizedtechniciancanreplacebattery.
8. Disconnectthe unitfromthepowersource.
9. UsebatterywhichapprovedbyLogitagforassemblyattheunit.
10. Batterymustberechargeabletype3.7‐4.2V.


Replacementprocedure:
 Disconnecttheunitfrompowersourceandallothercablesconnectiontotheconnectorspanel.
 Openthe4screwsofthedevice.
 Removethebattery
 Connectthenewbattery

Installationinstructions

Installationpositions:
 Vertically–placedonashelforatable,antennasadjustedandpointedtotheceiling.
 Wallmount‐Screwedtothewallbyusingthesidebracke ts,antennasadjustedandpointedto
theceiling.
PowerConnection:
 Connectthepowerconnectiontothepowersocketandtotheunitat"po wer"connection.
Relayandantennas:
 Relayconnection–seeRelay(Drycontact)connectionsection.
 Antennas–connecttheantennastoanyportavailableonLFantennasports1‐4.
