User's Manual




LT‐D‐0211rev16

Page|71


1. CheckthattheLFantennaisactivatedasdescribedonsection‐LFsignaldoesnottransmits
2. CheckthatallUHFantennasareconnectedtotheunit(UHF1‐4)
3. Disconnectthe poweradaptorfromtheunitandconnectback
Whentheunitisbackonwaitfor1minuteforallcomponentstoreset.
Clickonconnectthroughthetechniciansoftware





7.2.4 Tag
doesnotrespond
 Incaseatagdoesnotrespondpleaseperformstepsonchapter‐LFsignaldoesnottransmits
 In case the step above did not help, connect a second antenna to a different port and check tag
response. This checkis incase the tag isconfigured tostop transmitting aftera  certain amount of
timeneartheLFantenna.Thesecondantennashouldreactivatethetag.

Noteth atiftheparameter"sleepwithinLFfiled"isonitmightbethatthetaghasbeendetecteda
largenumberoftimeneartheantennaandhasbeendisabledforaperiodoftimedefined.
Ifthestepsabovedoesnothelpperformstepsonsection‐The
unitisonbutnoresponse









