2.
Product details: DUT power setting: The PA has 7 levels from the lowest power to highest (PA7). Our products use the 2nd level (PA6 ) . Caution: The test program is default that DUT emits max. power ( highest level ) but all our FW setting only use 2nd level. Please keep in mind that make sure to lower the power during every single test. Test procedures: test program : WUSBLP_Test.exe after execute it you will see the panel below : How to use : 1. CW: 1) press " CH Center Freq.
) if one wants to cease CW mode, please press “ STOP” 2. Modulated signal: 1) press “Random Data” to have modulated signal; then press " 2402 MHz" or "2441 MHz" or " 2481 MHz" to choose lowest, middle and highest frequencies; for other frequencies, please press “channel –“ or “channel +” to select channel. 2) press “ PA Bias – “ once to select output power PS: don’t press more than once otherwise the power won’t be correct.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
emissions, PC peripheral requirements, etc.). IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization.
IMPORTANT NOTE: IC Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
