Instructions

6
INTRODUCTION
Congratulations on buying the Saitek Pro Flight Yoke System. The Pro Flight Yoke
features realistic controls congurable for all the major ight simulation software to
make your ying experiences more realistic.
FEATURES:
• 8-way point of view hat switch
• 6 x 2-way rocker switches
• 2 x Single-function buttons
• 3-position mode switch
• ST Programming Software (ST) allows gamers to congure their controls to suit their
preferred gaming style, and to save the congurations as personal proles.
INSTALLING THE FLIGHT YOKE AND THROTTLE QUADRANT
First, x the Flight Yoke to your table or desk by inserting
the prongs of the mounting clamp into the holes on the
yoke base and then tightening the screw mechanism
until the yoke is rmly attached (be careful not to
overtighten the screw as you may damage the
clamp). Next, screw the mounting plate to the Throttle Quadrant
using the four screws provided. You can screw the plate to one
of two sides of the quadrant depending on how you want to mount the quadrant - either in
front and below your table or on top of it. Please note that whichever way you choose to
mount the quadrant, ensure that as you look at the unit the rocker switches are at the bottom.
Now tighten the throttle unit clamp’s screw mechanism until it is rmly attached to your table.
You can also position the Throttle Quadrant on the left or right side of the Flight Yoke.
Now, connect the Throttle Quadrant to the Flight Yoke with the PS/2 connector provided. Your
Throttle Quadrant comes supplied with additional lever knobs to congure any combination of
throttle, aps,