User's Manual

Establish a Connection - Important!

Make sure you have connected the mini-receiver to the USB

port of your computer, installed the batteries in the

presentation device, and have installed the software.

Turn on the presentation device by moving the Mode switch to

either Mouse Mode or Presentation Mode.

Press and release the Connect button on the presentation

device (picture1).

The presentation device emits a “beep.”

The

Connection Status LED above the Forward (left) button is red and blinks

fast until a connection is made; then it turns green and blinks slowly.

You have now established a connection between the presentation

device and the mini-receiver.

If a connection has not been made and the Connection Status

LED on the presentation device is slowly blinking red, press the

Connect button on the bottom of the mini-receiver (picture 2),

then press the Connect button on the presentation device.

Connection Status LED and Communication Range

•

After connection, the Connection Status LED blinks green to indicate

each time a data packet has been sent from the presentation device to

the mini-receiver.

•

Should the presentation device move out of range from the mini-

receiver, the Connection Status LED on the presentation device turns

red and blinks fast as long as the presentation device is out of range.

Using the Presentation Device

The Logitech

Cordless Presenter

™

has two modes: Presentation Mode and Mouse Mode. Use the Mode switch on

the bottom of the presentation device to turn on the device and to switch between these two modes.

Connect button on bottom

of mini-receiver

Press connect

button