User's Manual

Logitech® io
2 Digital Pen with Bluetooth®
Page - 5
Additionally, the digital pen can be charged using a wall or car charging adapter, which connects to the USB cradle (a
qualified wall socket charger is provided in the Logitech Digital Pen with Bluetooth product package). These
accessories are also available for separate purchase from Logitech. Contact your Logitech regional sales representative
for more information about these products.
While the digital pen is charging, the Battery Status LED will slowly flash either red, yellow, or green depending upon
the power level of the battery. If the battery is completely empty, it may take up to ten minutes before the LED flashes
to indicate that the digital pen is charging. Refer to the table below for more information about the Battery, Memory,
and Bluetooth Status LED:
After the digital pen has been fully recharged, remove it from the USB cradle. Or disconnect the USB cable from the
computer.
Replacing the Ink Cartridge
When the ink cartridge in the digital pen runs out, replace it with one of the
refills supplied with your digital pen.
Note Only replace the ink cartridge when it is empty. The process of
removing the cartridge can damage the cartridge tip. If you
attempt to reuse a cartridge with a damaged tip, it may leak ink.
1. Remove the cap from the digital pen.
2. Place the ink cartridge tip in the hole in the pen’s cap clip .
3. Tilt the pen cap slightly clockwise. Pull the cap away from the pen
. The ink cartridge should pull away with the cap. Remove the
cartridge completely from the pen and discard it.
4. Insert a new ink cartridge into the digital pen.
5. Press the ink cartridge tip against the surface of the digital notebook
to secure it in place .
If you need ink cartridge refills, in the United States or Canada please check
the Logitech
®
web site at www.iodirect.com. In Europe check
www.logitechio.com.
The ink color and type is important for the functioning of the Logitech io2 Digital Pen. If you purchase ink cartridge
refills from another manufacturer, make sure the refills are ISO 12757-1 D1 compliant and use blue ink. This color
works best. Black and green ink cartridges from other manufacturers are more likely to affect the digital pen's ability
to record your writing.
Color of LED Battery Level
Green Battery has full charge. Stop charging the digital pen.
Yellow Battery is less than 50% charged.
Red Battery is low. Recharge now.
Blinking Red Battery level is critically low. You must recharge now.