Universal Remote User Manual

Automation@Home

www.automation-at-home.com

Page 1

This manual will show you how to setup Logitech Harmony Universal Remote to control X10

home automation system .

Hardware Requirement :

1) Logitech Harmony Universal Remote e.g. Logitech Harmony 880

2) Marmitek IR \ RF Transceiver + Mini Controller , model number : IRRF7243U

3) Several X10 device e.g. X10-2026UK X10 Plug-in Module , X10-2222 Single Button Dimmer Wall

Switch …etc

In following example :

We have several X10 device and already assign specific X10 address.

Bedroom - Light is B1

Living Room - Light 1 is B3

- Light 2 is B4

- Low Voltage Halogen Lamp 1 is B9

- Low Voltage Halogen Lamp 2 is B10

Toilet - Light is B5

Kitchen - Light is B6

Setting for Marmitek IRRF7243U :

Please set the correct House code on IRRF7243U

e.g. for above sample , please set to House Code B

Run the Logitech Harmony Remote Software and follow below step to setup the remote.

1) Click “Devices” tab.

PAGE 1
Automation@Home www.automation-at-home.com This manual will show you how to setup Logitech Harmony Universal Remote to control X10 home automation system . Hardware Requirement : 1) Logitech Harmony Universal Remote e.g. Logitech Harmony 880 2) Marmitek IR \ RF Transceiver + Mini Controller , model number : IRRF7243U 3) Several X10 device e.g.
PAGE 2
Automation@Home www.automation-at-home.com 2) Click “Add Device” button.
PAGE 3
Automation@Home www.automation-at-home.
PAGE 4
Automation@Home www.automation-at-home.com 8) After you add the Light Controller it will appear on the “Devices” page. Then click “Settings” in “Light Controller Section” 9) Select “Change the behavior of buttons” then click “NEXT >” 10) Assign the X10 command to specific button , e.g. Mute Button – All Lights Off Volume Up Button – Bright Volume Down Button – Dim Up Arrow Button – On Down Arrow Button – Off Prev.
PAGE 5
Automation@Home www.automation-at-home.com 11) Assign the on-screen button label , in this example : AllLightOff – AllLightOff AllLightOn – AllLightOn Bedroom – Light 1 LivingRoom1 – Light 3 LivingRoom2 – Light 4 Toilet – Light 5 Kitchen – Light 6 Spotlight 1 – Light 9 Spotlight 2 – Light 10 After that , click “ DONE ” 12) Click “DONE” for finish the setting 13) Click “Update Remote” to upload the setting into the Harmony Remote.