User Manual

12
MAINTENANCE
Key Pass Battery Replacement
You will need: 1 Lithium watch battery (#CR-2032), which can be purchased at
most retail stores that sell batteries.
To ensure optimum performance of your system and uninterrupted cover-
age, we recommend changing your batteries every six months or when you
change the batteries in other household items like your smoke detectors.
1. Open Key Pass: If the back of your Key Pass has a screw, use a small Philips
head screwdriver to remove the screw. If the back of your Key Pass does not
have a screw, use a small coin like a dime and insert into the indented slot on
the one side of the case. Gently pry apart the two halves of the Key Pass. You
have now exposed the interior of the Key Pass.You will notice a circular bat-
tery retained by a semicircular battery holder.
2. Remove old battery: Push the battery out of its holder using a pencil
or other non-conductive (non-metal) tool. Notice the + sign on the face of
the battery. You will want to put the new battery in with the + sign facing
upward. Discard the old battery in household trash. It is non-corrosive and
non-hazardous.
3. Replace battery: Insert a new battery into the battery holder.The battery
MUST be installed with the + sign facing up. Slide the battery into the holder
until it sits snugly in the holder. The red light on the face of the Key Pass
should flash several times immediately after properly installing a battery.
4. Close the Key Pass: Reassemble the Key Pass by snapping the two halves
of the case together. If your case has a screw, insert the screw into its hole
then tighten the screw until it is just snug. Note the date you replaced the
battery.The battery should last approximately six months.
503287_LoJack.comp 6/20/05 8:55 AM Page 15