Operations Manual

RTU5 Operations Manual Revision: "1"
Page 10 of 12 Document ID #: 4001-00xx-SO
LoJack Confidential Proprietary
Document Not To Be Copied Or Retransmitted In Any Form Without Prior Authorization
Section 3 Warnings and Cautions
EMC
This product as supplied meets the requirements of the European Union Directive 89/336 EC and is
eligible to bear the CE marking.
It meets the requirements for an industrial environment. However, it must be noted that because the
unit is user configurable, certain precautions will be required to maintain that compatibility.
The RTU5 unit must be grounded. The grounding lead should be as short as possible and
connect to the incoming cabinet earth ground.
If a rack-mounted monitor is used, it is recommended that the monitor body grounding stud be
connected using as short a lead as possible to the PC body grounding stud.
Failure to comply with these recommendations may invalidate the compliance with the EMC
Directive.
WARNING: This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
WARNING: The electronic assemblies within the unit are susceptible to electrostatic discharge
(ESD). Take anti-static precautions before handling, otherwise damage can occur.
Note:
Appendix "A" This product is not intended to be sold in the
consumer market. It has been intended for use by only authorized
personnel and as such should be in a secure location to protect
unauthorized access.