User guide

Building American Quality… With A Lifetime Warranty!
General Installation Notes:
Please read instructions completely before beginning installation. If
you have any questions please call.
Before starting installation, scotch vehicle tires to avoid accidental
movement of the vehicle. Do not attempt to install this product while
the engine is running. Disconnect the negative battery cable before
beginning installation.
Make sure the engine, transmission, body and frame are properly
grounded. We recommend applying anti-seize lubricant to all alumi-
num threads before final assembly.
This kit is designed to be used with a Lokar Throttle Cable
and/or Kickdown Cable.
Refer to Fig. 1 for the component names.
Step 1: Install the aluminum linkage bracket onto the rear of the
carburetor base using the two 5/16"-18 x 1-1/2" socket head
bolts that are supplied with the kit. Fig. 2
Step 2: Install the tear drop onto the carburetor linkage arm. If you are
using a kickdown cable, the tear drop will be held in place by
the hex carb fitting and nylock nut that come with the Lokar
kickdown kit (the hex carb fitting is not included with the Billet
Aluminum Throttle Bracket & Springs). Fig. 3 If a kickdown cable
is not being used, attach the tear drop to the carburetor linkage
arm using a 1/4" x 1/2" long bolt and nylock nut (not supplied).
Tighten the nylock nut until the tear drop is snug. Then back the
nut off just enough for the tear drop to swing freely.
Step 3: Connect the inner and outer springs to the small hole in the
aluminum linkage bracket and to the tear drop. Fig. 4
Step 4: Install the Lokar throttle and/or kickdown cables according to the
instructions included with those parts. See Fig. 5 for a completed
installation with Lokar throttle and kickdown cables.
TOLL FREE 1-877-469-7440 • [phone] • FAX [phone] • [e-mail] • www.lokar.com
®
Billet Aluminum Throttle Bracket & Springs
for Edelbrock and Carter AFB Installation Instructions
Billet Aluminum Throttle Bracket & Springs
for Edelbrock and Carter AFB Installation Instructions
INS0029 Rev. 02/13/13 RPD 04/28/14
Page 1
© 2007 Lokar, Inc.
Aluminum
Linkage
Bracket
Inner & Outer Springs
Tear Drop
5/16"-18 x 1-1/2"
Socket Head Bolts
5/16"-18 x 1-1/2"
Socket Head Bolts
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Tear
Drop
Hex Carb Fitting
(not included)