Owners manual

Building American Quality… With A Lifetime Warranty!
General Installation Notes:
Please read these instructions completely before beginning the
installation. If you have any questions please call.
Before beginning the installation, disconnect the negative battery cable
and use wheel chocks to block the vehicle's wheels.
We recommend using anti-seize lubricant on all aluminum threads.
IMPORTANT APPLICATION INFORMATION: The Lokar Throttle
Pedal is designed for use with a Lokar Throttle Cable. Stock style
throttle cables will not work. If your vehicle has an automatic
transmission, installation of a Lokar Kickdown Kit (if applicable) is
strongly recommended. Lokar Throttle Cables and Kickdown Kits are
application-specific according to the type of induction system and the
transmission model.
Refer to Fig. 1 for the component names.
Step 1: Remove any existing throttle pedal assembly and linkage
components.
Step 2: Determine your desired mounting location. If needed for
clearance purposes, the upper and lower pedal arms can
be switched left and right while the pedal is disassembled. If
you purchased the Vertical Offset Mounting Throttle Pedal,
the pedal cradle can be installed in either direction, with the
pedal axle closer to the top or to the bottom. Rotating the
offset pedal cradle will raise or lower the pedal assembly by
approximately 1-1/2".
Step 3: Disassemble the throttle pedal assembly by removing the
#10-32 x 3/8" flat head screw and aluminum end washer
from either end of the pedal axle. You will need two 1/8"
Allen wrenches (not included). One will be used to keep
the pedal axle from spinning while you use the second one
to remove the screw from the opposite end. Fig. 2 Pull the
pedal axle out of the pedal cradle.
Step 4: Remove the Delrin® bushing and the upper pedal arm from
the splined bushing. If the upper pedal arm needs to be
switched to the opposite side of the lower pedal arm for
clearance purposes, push the splined bushing over so that it
protrudes from the opposite side of the lower pedal arm, and
remove the other Delrin® bushing from the splined bushing.
Reinstall the upper pedal arm and Delrin® bushing(s) onto
the splined bushing with the upper pedal arm pointed up at
the desired angle, so that the upper pedal arm will be parallel
to the firewall with the throttle pedal at rest. Fig. 3
TOLL FREE 1-877-469-7440 • [e-mail] • www.lokar.com
®
Competitor Series Throttle Pedal
Installation Instructions
Competitor Series Throttle Pedal
Installation Instructions
INS0044 Rev. 02/17/2016
Page 1
© 2000 Lokar, Inc.
#10-32 x 3/8"
Flat Head Screw
#10-32 x 3/8"
Flat Head Screw
Aluminum
End Washer
Aluminum
End Washer
Upper Pedal Arm
Lower Pedal Arm
Throttle
Pedal
Pedal Axle
Splined
Bushing
Pedal
Cradle
Delrin®
Bushing
Delrin®
Bushing
Fig. 1