User's Manual

Table Of Contents
Introduction
Insert SIM card and battery
Long press power supply key for 3s to turn it off;
Slide the back cover downwards and remove it;
Remove the battery. Insert SIM1 (per the mark “SIM1” on the card slot. The contactor shall face
down (note the notch on the SIM card is in line with the slot). Push the SIM card inwards from the
card slot until it absolutely fits the slot. Insert SIM2 in the same manner.
Insert the battery with metallic contact aligned to thephone battery contact and replace the back
cover.
Note:
1.This User Guide is designed for both SIM cards inserted by selecting [Settings→Call
Settings→Dual-SIM→Standby mode→Dual SIM dual standby]. If only one card is inserted or no
Dual SIM dual standby is set up, the screen and options may differ from this manual.
Insert memory card
This phone supports the T-Flash memory card. After it is inserted, you can browse or copy, etc. the
files stored in the memory card. Also, the disk spaceof this phone can be expanded.
Remove the back cover and battery and turn over the cover of the memory card in the
direction as shown thereon;
Let the side of the memory card bearing metallic contact face down, insert the narrower end
into the slot until absolutely fitted by it, and replace the back cover
Warning:
Please don’t insert or remove the memory card quickly or frequently to avoid damage
Battery charging
The phone battery may be charged with travel charger
Insert the battery in the phone correctly;
Open the rubber cover on the left side of this device below the screen,,let the charger arrow
towards the screen, insert the charger plug into the screen, and connect the charger to the
standard power supply socket.
After the charger is inserted, the battery intensity icon on the upper right of the screen
starts running, which means the battery begins charging. When it is charged full, the icon
stops running and the battery icon on the screen comes full .
After charging is over, cut off the connection between the charger and the standard power
supply socket and then that between this device and the charger by pressing the buttons on
both sides of the charger