User's Manual

Run Locate Mode
Run locate is used to immediately locate any misplaced coasters around the restaurants (ideal during closing
hours).
When activated:
• A signal is sent out to ALL guest pagers.
• Pagers will Beep or Flash until returned to charging unit or batteries removed.
To activate
1. Press SETUP and enter Password.
2. Press 3 (OTHER).
3. Choose 3 (Locate Pagers).
4. Press ENTER to begin locating pagers.
Cell Phone Paging/Messaging
Overview
The Cell Phone interface is used to extend the capability of the on-premise paging system allowing you to
notify people on their cell phones.
Cell phone paging is an optional service. This service is not required for normal over-the-air UHF paging
operations.
When a Guest’s Cell Phone number is entered, the transmitter will store the number as a Pager Number
between 500 and 999.
System Requirements
Cell Phone Paging requires broadband internet service, a CAT-5 Ethernet cable, and a contract with
Long Range Systems. The bandwidth usage for SMS is about 1.5 kB for each SMS page sent, few hundred
bytes for sending pages. The bandwidth usage for cloud reporting is about 0.6 kB for each session uploaded.
The T7471 is an ARM processor running an embedded RTOS. Viruses and worms targeting Windows, Mac,
Linux, Android, iOS, etc, can not infect it. If you would like to utilize cell phone messaging, please contact
your local LRS office or call 800.437.4996.
Two Steps to enable the Cell Phone Paging:
Step 1
1. Press SETUP and enter Password.
2. Press 3) Other.
3. Press F2 (Down).
4. Press 3) Network.
5. Press 1) Configure Network.
6. Press 2) Enabled
7. Press F1 (Yes) to enable or press F4 (No) to disable Network.
Long Range Systems 28 LRS Connect Transmitter User Manual