User's Manual

Long Range Systems 20 T7400A User Manual
Adjust Transmit Power
The maximum output power of the transmitter is 120mW. The range may be increased or decreased from
the transmitter by adjusting this transmit power level. The power levels are 1 through 5. Default from the fac-
tory is power level 3.
To set the power level:
1. Press SETUP and enter Password.
2. Press F2 (DN) until the display shows 2: Transmit Power.
5. Press 2 (2:Transmit Power).
6. Set the required power level (from 1 through 5).
7. Press ENTER.
Assign Manager Pagers
1. Press SETUP and enter Password.
2. Press F2 (DN) until display shows 1: Mgr/2 Btns.
3. Press 1 (Mgr1/2 Btns.)
4. Select 1 to Assign Manager Pager 1, or 2 to Assign Manager Pager 2.
5. Type in new pager number and press ENTER.
Locating Misplaced Pagers
Two location modes are available for finding lost or misplaced pagers/coasters. Auto Locate automatically
searches at a preset time, Run Locate searches on demand.
CAUTION: Do not set auto locate to run or use run locate feature while pagers are handed out.
All pagers will be paged!
Auto Locate
Auto Locate sends a signal to ALL coasters/pagers at a preset time. The coasters/pagers will beep so that staff
can locate them.
Example: If closing at 11:30PM, the transmitter can be set to auto locate at 12:30AM, causing all miss-
ing coasters/pagers to beep at that time.
When activated:
• A signal is sent out to ALL coaster/ pagers.
• Pagers will Beep or Flash until the pagers are placed on the charging unit or the batteries go
dead. In the case of battery operated pagers, the battery must be removed to stop the beeping.
To activate:
1. Press SETUP and enter Password.
2. Press 3 (OTHER.
3. Press F2 (DN).
4. Choose 1 (1:Auto Locate) to program auto locate.
5. Press F1 (YES) to turn Auto-Locate mode on or press F2 (NO) to turn off.
6. If turning function ON, enter a starting Time of Day for Auto Location (HH:MM).
7. Press F1 (AM) or F2 (PM).
!