User's Manual

Note: more than 1 pager can be encrypted at once.
• The unit will wait 5 seconds and send out the signal.
•
The screen will display “prg encryption none” (or 128 bit key) then “Transmitting Key”.
• Continue this procedure with the remaining pagers.
Program Pager Vibration
The Program Vibration feature can program a set of Guest or Staff Pagers all at once to Vibrate or not Vibrate
when paged.
1. Be sure All Pagers are on the Charger.
2. Press SETUP and enter Password.
3. Press F2 (DN).
4. Press 1 to select 1) Program.
5. Press 2 to select 2) Prg Vibe.
6. Press 1 to select Guest Pagers or 2 to select Staff Pagers.
7. If selected Guest, select 1 for Coaster Pagers or 2 for Paddle Pagers.
8. Press F1 (Yes) to enable Pager to Vibrate, or F4 (No) to prevent the Pager from Vibrating.
9. Unplug the charger power supply.
10. When Pagers finish flashing, press ENTER.
11. Pagers will slowly brighten and dim to off to indicate they are being Programmed.
Note: Pagers will vibrate during glowing if vibration is enabled. Will not vibrate if vibration was
disabled.
12. When finished, plug the charger power supply back in.
Program Welcome Message
The Welcome Message on a Staff 4-Line Alpha pager can be customized to show something new when the
Pager is powered on.
1. Press SETUP and enter Password.
2. Press F2 (DN).
3. Press 1 to select 1) Program.
4. Press 3 to select 3) Prg Welcome.
5. Type in New Welcome Message and press ENTER.
Note: The welcome message has a 32 character limit.
6. Turn off and then turn on Alpha Pager.
7. Press ENTER.
8. Pager should Beep Once to indicate programming.
9. Cycle power on Pager to view New Message.
Long Range Systems 26 T7400A User Manual