User's Manual

Contrast
To set the Contrast Level
1. Enter the vibe/contrast menu as described above.
2
. Highlight the Contrast selection then PRESS and HOLD the SP5 pager Button until the screen shows.
SP5 Pager Screen
3. Press or hold the Select Button to the desired Contrast. The level will increase to max (NOTE:
screen could be dark and hard to read), Release the Select Button and press or hold again to
change the level back towards the minimum or to desired contrast.
4. To exit, wait 8 seconds. And the pager will go back to the vibe/contrast menu.
SP5 Pager Screen
5. To exit this menu wait 8 additional seconds.
Settings
To view the current pager settings
1. Remove pager from the charger or reset on the T9601, T9100, or T9101 reset terminals.
2. Press the Select Button repeatedly to scroll through the settings:
C1: [System ID number] and Pager ID number
C2: [System ID number] and All Page number
C3: [System ID number] and System ID number
G: Group number
Enc: Encryption enabled (128) or none
Ver: Current Firmware Version
3. To exit, wait 8 seconds.
Messages
The pager stores the last 5 received messages.
To view the messages:
1. Press the Select Button once.
2. Messages 2 lines in length will show a > symbol on the end of the first line and a < on the second line.
Messages over 2 lines in length, the middle lines will show “< the next line of the message >”.
3. Press the Select Button to continue scrolling forward through the message or messages.
Time
Pager will display the current time. The T7400A transmitter automatically updates this feature. If the time
does not appear, a flashing star will appear on the right side of LCD to show pager is operational.
Programming
To program the pager see pg. 25
VIBE
VIBE CONTRAST
Long Range Systems 33 T7400A User Manual