User's Manual

INSTALLATION AND SETUP
Basic Installation
1) Plug the 12V power supply into the side of the Transmitter.
2) Connect the serial cable from the connector on the Transmitter to the serial port on the host com-
puter.
3) Note the COM Port that the serial cable is connected to on the host computer.
4) Open HyperTerminal on the host computer.
5) Assign a Name for the new connection.
6) Select the COM Port coming from the serial cable.
7) Use the following settings:
Bits per second: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
8) Type ECHO1 and press ENTER. (This echo function will allow you to see what is being typed.)
9) You are now ready to use the interface.
Note: At any time, use the STAT command to view any changes.
Long Range Systems 2 TX-7470-C232 User Manual
Screen View of ECHO ON
Screen View of Typing ECHO