User's Manual

SP4 Staff Paging Mode

M1 – Vibe 1 Time, LED 1 lights

M2 – Vibe 2 Times, LED 2 lights

3 – Vibe 3 Times, LED 3 lights

M4 – Vibe/Beep 1 Time, LED 1 lights

M5 – Vibe/Beep 2 Times, LED 2 lights

M6 – Vibe/Beep 3 Times, LED 2 lights

Configuring Your Messages

The POCSAG Staff and 3 Digit Pager message can be edited and changed to a user defined set of messages.

Please refer to LRS Programmer instructions for changing messages.

System ID

To change the System ID, press 9-0-x-Prog (x = sys ID from 0 to 49).

Please contact Long Range Systems before changing the System ID of your transmitter.

Range Test

The Range Test feature is used to broadcast a continuous signal.

To turn on Range Test, press 9-9-2-Prog

When the range test is active, the LCD will display an 8 moving across screen. Then the red LED will trans-

mit once every 10 seconds.

Pager Programming

The T9560 can program any LRS Pager type. The transmitter’s current mode of operation must match the de-

sired pager to program. (Example: To program an SP4, the transmitter must be set to the SP4 Staff Mode.)

To program an SP4, coaster, or paddle pager:

1) Remove the pager from the charger

2) Allow the pager to complete the vibration and flashing sequence

3) Press into the keypad a number from 1-799 and press PROG. (Example: For Pager #200, press

2-0-0-PROG)

4) The red LED in the top right corner of the transmitter will light up once.

5) The pager will glow once cycle to indicate it received the programming.

To program an Alpha Pager or 3 Digit Pager:

1) Remove the battery from the pager

2) Re-insert the battery into the pager

Long Range Systems 4 T9560 MT User Manual