User's Manual

3) Press into the keypad a number from 1-799 and press PROG. (Example: For Pager #200, press 2-
0-0-PROG)
4) The red LED on the top right corner of the transmitter will light up three times.
5) The pager will beep three times to indicate the single pager capcode, all page capcode, and sys-
t
em ID.
Group Paging and Programming
The T9560 has the ability to program groups into the LRS POCSAG Staff and 3 Digit Pagers.
Up to 5 groups can be programmed into the transmitter and pager.
Please note that when Groups is enabled, groups are numbered 1-9, and paged using 001 through 009.
Any POCSAG Staff Pager or 3 Digit Pager with a programmed pager number 1-9 matching a set group num-
ber, will be programmed +100 to the pager number.
Example:
If any Group is set, Pagers 1-9 become 101-109, and pager is programmed as #1, the pager will display Pager
#101 for the individual pager number and 1 for group number.
To turn on Group Paging, press 9-9-1-PROG.
To turn off Group Paging, press 9-9-0-PROG.
When Group Paging is enabled, select up to 5 group numbers to set into the transmitter.
To set press G-0-0-#-PROG, where # is a number from 1 to 9.
Repeat for up to 5 group numbers.
Example, to set Group 2, press G-0-0-2-PROG.
To program Groups to a POCSAG or 3 Digit Pager, refer to pager programming section.
While the pager is programmed, the red LED on the transmitter will blink 1 additional time for each group to
program.
The pager will beep an additional time for each group programmed.
Example: If 3 groups are set, the red LED will blink 6 times on the 9560, and the pager will beep 6 times.
To Page a group, press the G key, followed by the group number, then a message key.
Example: To Page Group 2 with Message 2, press G-2-M2 or G-002-M2.
Each Group must be individually set into The Transmitter and then that Group of pager programmed.
Low Battery Alert
When the transmitter’s battery is low, the LCD will display “Low Bat”
Factory Reset
To reset the transmitter factory defaults, press 0-0-0-Prog. 1 + h.w. button for system reset, 2 + h.w. button
for factory reset.
Long Range Systems 5 T9560 MT User Manual