User's Manual
GENERAL INFORMATION
The LRS ZB-Beacons are used in conjunction with the LRS Table Tracker systems.
They are used as an on-premise locating system to increase eciency by identifying
customer’s’ location, typically to deliver services or goods. Beacons are powered by
AAA batteries, water resistant, and can flash when the user presses the button during
configuration.
SETUP AND USE
To begin using your beacons, power them up by adding batteries.
Batteries Installation
1. Remove the four screws to open up the case and access the board.
2. Locate the battery holder and place one AAA battery on each battery
compartment. (Do not place the lid back on as you need access to the board
to complete the configuration.)
WARNING:
Do not use rechargeable batteries. Damage caused from improper power sources
including but not limited to the incorrect batteries is not covered under the standard
warranty. If you’re uncertain about which battery to use, contact our customer sup-
port department at 800.437.4996
Configuration
Configure the location that each beacon will broadcast.
1. Launch the beacon configurator application to associate each beacon to an
areas in your location. Access the beacon configurator by typing
[gateway IP]:8080/# into a browser on the same network.
2. When prompted, press the button on beacon. This will initiate the configura-
tion mode of the beacon to set corresponding ZB preset of your system into
the
beacon. Also, the MAC address of the beacon will be stored on the LRS Gate-
way to save the association to the assigned area.
3. The light on the beacon will flash slowly when the button is initially pressed
and then rapidly for approximately 5 seconds once successfully configured.
Afterwards, the light will turn o to preserve energy.
3