Instruction Manual

Lock On Mode
Link Mode (Alternative to Using Dip Switches)
Lock On Mode allows any combination of traps to be locked in and launched with a press of a button
or a verbal command without pressing each trap button each time.
To lock in a single trap (Voice Models Only), press and hold a trap button for 4 seconds. The selected
WUDSLVQRZORFNHGLQ:KHQUHDG\FDOO³3XOO´LQDQRUPDOWRQHRIYRLFHWR¿UHWKHGHVLJQDWHGWUDS7KH
WUDSZLOO¿UHDQGWKHGreen Tx Light will go out. After 4 seconds, the Green Tx Light will begin to
ÀDVKDJDLQDQGWKHWUDQVPLWWHUZLOOEHUHDG\WR¿UHWKHVDPHWUDS
To lock in multiple traps, press and hold True Pair/Enter for 4 seconds. Press the desired traps that
\RXZLVKWR¿UHVLPXOWDQHRXVO\7KHVHVHOHFWHGWUDSVDUHQRZORFNHGLQ:KHQUHDG\SUHVVTrue
Pair/Enter (Non-Voice) RUFDOO³3XOO´LQDQRUPDOWRQHRIYRLFH9RLFHWR¿UHWKHGHVLJQDWHGWUDSV7KH
WUDSVZLOO¿UHDQGWKHGreen Tx Light will go out. After 4 seconds, the Green Tx Light will begin to
ÀDVKDJDLQDQGWKHXQLWZLOOEHUHDG\WR¿UHWKHVDPHWUDSV
To exit Lock On Mode, press the ON button.
1
2
3
4
5
6
Set desired Field ID Channel on the
transmitter.
Power on desired receiver with all dip
switches set to the RSHQRႇposition.
Press the desired trap button that you would
like to assign to the receiver. The transmitter
will link the receiver to that trap address
and current channel. If the receiver linked
successfully, the Red Power LED and Green
Tx LED will alternately blink. If the link failed,
the Red Power LED ZLOOWXUQRႇIRUVHFRQGV
Press and hold On and Enter until the red
Power Light and the green Tx Light on the
WUDQVPLWWHUVWDUWDOWHUQDWHO\ÀDVKLQJ7KHUHG
Power Light will go solid. It is now in Link
Mode.
The red Link Mode light on the receiver will
go solid. The transmitter and receiver are now
linked. Repeat this process to link another
receiver.
Link Mode DOORZVXVHUVWRZLUHOHVVOLQNUHFHLYHUVWRVSHFL¿FWUDSEXWWRQV%HVXUHWKDWWKHUHFHLYHU\RX
wish to link to is in Link Mode. If you are using a voice model make sure that there is no microphone
attached to the device.
To exit Link Mode, press and hold On until
the Red Power LED WXUQVRႇ7KHRed
Power LED will turn back on. The unit is now
back in normal operation.
Link LED
Will blink for 15
seconds
6HWWRRSHQRႇ
position
Indicates power
is on
Dip Switches
Power LED
3
Transmitter’s Field ID
Must Be Set (Channel
1 Shown Here)
R-4300 Dip Switches
Set to Link Mode (All in
WKHRSHQRႇSRVLWLRQ