Operator's Manual Owner manual

OPERATING NOTES FOR BATTERY PACK
1. Battery must be charged before using the tool for the first time. Batteries reach full
performance after about five charge / discharge cycles.
2. Always have the 3-position Forward / Reverse / Neutral Lock Switch in the center
position when removing or inserting the battery to avoid unintentional start.
3. Remove the battery from the tool. Press the Battery Release Button and remove the
battery.
4. Place battery on the charger.
5. To charge, plug the charger’s AC input plug into a 120V household current.
6. When the battery is charging, a red light is on. When the battery is finished charging,
a green light comes on.
7. IMPORTANT: Ensure that the charging takes place in a safe, secure location away
from liquids.
8. Normal charging time is approximately 1 hour.
9. To insert the battery into the tool, simply slide the pack in until Battery Release
Button lock spring clicks.
10. When charging more than one pack in succession, allow 15 minutes between
charges.
11. The battery discharges slowly over time, even when not used, and may require
recharging before you use the tool.
12. After many charge / discharge cycles, your batteries will lose their ability to hold a
charge. They should then be replaced. Dispose of batteries at an appropriate waste
disposal facility. They contain cadmium, so do not throw batteries away in common
trash receptacles.
13. Charge the battery 1 hour every 3 months even if you do not use it, as battery
discharges slowly over time.
14. Please disconnect the AC/DC adapter after the battery is charged, the charger and
AC/DC adapter may be damaged if plugged in the 120V outlet continuously for 24
hours.
WARNING! Never charge the battery until it is cooled down, charging the hot battery
may cause the battery to explode.
!
WARNING! Dispose of batteries at an appropriate waste disposal facility. They contain
cadmium, so do not throw batteries away in common trash receptacles.
!
4
OPERATING PROCEDURES
WARNING: When the machine is obstructed, please turn off the switch right away
and check if the work piece is right. An obstruction may cause the machine
motor to be burned.
REMEMBER: This tool is cordless and does not need to be connected to a
power supply.
CAUTION:
 Do not expose either the electrical tool or charger to the rain or water
 Do not overcharge the battery as this could damage the battery’s cells.
 Do not force the tool If the tool is stalling, it is possible that the battery
power is low. If so, stop working and recharge the battery pack.
 To prolong the life of the tool, do not continually work for more than 20
minutes at a time.
!
!
!