Installation Instructions

www.longer3d.com [e-mail]
19
7. Enter your device name and X-axis and Y-axis travel, and then press Enter to confirm.
Equipment name: RAY5
X-axis travel is 400mm
Y-axis stroke is 400mm
8. Select Front Left as your origin X, Y and activate Auto “Home”, then press Next.
9. Select RAY5, and then press Set as default.
10. Your RAY5 is ready to be used in LightBurn software.
PS. If you think the trial version is good, you can buy it for a fee.
Step2. User guide
Connect the serial port line to the engraving machine and the computer respectively, and find the
serial port number driven by the USB converter in the device manager(COM4)；
Correspondingly select (COM4) on the serial port, and the engraving machine is connected to the
computer software at this time