Installation Instructions

www.longer3d.com [e-mail]
32
Question6:
Filament does not stick to the platform
1. After the user gets the 3D printer, if the leveling is found to be curled
on the first layer of silk, it feels like it is gently falling on the platform. It
can be judged that the leveling is not adjusted, and the nozzle is too
high from the hot bed. ,
2. At this point we need to re-level, the quality of the leveling can largely
determine the success rate of the part printing.
3. In addition, in order to ensure good contact between the model and
the platform, we can set the larger plane of the model face down when
slicing, and can also be set in the slicing software to add Raft to the
model, which can make the model stick to the platform. Firm.