Owner's manual

AT Commands for CX930xx Modem Reference Manual
3-34 Conexant 102752B
R This command will be accepted, but not acted
on.
S=n Dial the number stored in the directory (n = 0 to
3). (See &Z.)
! Flash: the modem will go on-hook for a time
defined by the value of S29. Country
requirements may limit the time imposed.
W Wait for dial tone: the modem will wait for dial
tone before dialing the digits following "W". If
dial tone is not detected within the time specified
by S7 (US) or S6 (W-class), the modem will
abort the rest of the sequence, return on-hook,
and generate an error message.
@ Wait for silence: the modem will wait for at least
5 seconds of silence in the call progress
frequency band before continuing with the next
dial string parameter. If the modem does not
detect these 5 seconds of silence before the
expiration of the call abort timer (S7), the
modem will terminate the call attempt with a NO
ANSWER message. If busy detection is enabled,
the modem may terminate the call with the
BUSY result code. If answer tone arrives during
execution of this parameter, the modem
handshakes.
& Wait for credit card dialing tone before
continuing with the dial string. If the tone is not
detected within the time specified by S7 (US
models) or S6 (W-class models), the modem will
abort the rest of the sequence, return on-hook,
and generate an error message.
, Dial pause: the modem will pause for a time
specified by S8 before dialing the digits
following ",".
; Return to command state. Added to the end of a
dial string, this causes the modem to return to the
command state after it processes the portion of
the dial string preceding the ";". This allows the
user to issue additional AT commands while
remaining off-hook. The additional AT
commands may be placed in the original
command line following the ";" and/or may be
entered on subsequent command lines. The
modem will enter call progress only after an
additional dial command is issued without the ";"
terminator. Use "H" to abort the dial in progress,
and go back on-hook.
^ Toggles calling tone enable/disable: applicable to
current dial attempt only.
( ) Ignored: may be used to format the dial string.
- Ignored: may be used to format the dial string.