Operating Instructions
FCC Statement
This device complies with part
15
of
the FCC rules. Operation
is
subject
to
the following two conditions:
(1)
thi
s device may not cause harmful interference,
and
(2) this device must accept any interference received,
incl
uding
interference that may
cause undesired operation.
Changes
or
modifications not expressly approved
by
the party responsible for compliance could void the
user’
s authority
to
operate the equipment.
NOTE: This equipment
has
been tested
and
found
to
comply with the limits for a Class B digital device, pursua
nt
to
part
15
of
the FCC Rules. These limits are designed
to
provide reasonable protection against harmful inte
rference
in
a residential installation. This equipment generates uses
and
can radiate radio frequency energy a
nd,
if
not installed
and
used
in
accordance with the instructions, may cause harmful interference
to
radio com
munications. However, there
is
no
guarantee that interference will not occur
in
a particular installation.
If
this
equipment does cause harmful interference
to
radio
or
television reception, which can
be
determined
by
turn
ing
the equipment off
and
on, the user
is
encouraged
to
try
to
correct the interference
by
one
or
more
of
the
following measures:
‐
Reorient
or
relocate the receiving antenna.
‐
Increase the separation between the equipment and receiver.
‐Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
‐Consult the dealer
or
an
experienced radio/TV technician for help important announcement
Important Note:
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used
in portable exposure condition without restriction.
Important Note:
In
the
event
that
these
conditions
cannot
be
met
(for
example
certain
laptop
configurations
or
co-location
with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID cannot be
used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the
end product (including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
The
final end product must
be
labeled
in
a visible area with the following" Contains FCC ID:
2ART3-FT-B"
Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to install or
remove this RF module in the user’s manual of the end product which integrates this module.
The end user manual shall include all required regulatory information/warning as show in this manual.