Quick Start Guide

- 17 -
of the relevant scientific literature. For example, over 120 scientists,
engineers, and physicians from universities, government health agencies,
and industry reviewed the available body of research to develop the ANSI
Standard (C95.1). Nevertheless, we recommend that you use a hands-free
kit with your phone (such as an earpiece or headset) to avoid potential
exposure to RF energy. The design of your phone complies with the FCC
guidelines (and those standards).
 Use only the supplied or an approved replacement antenna. Unauthorized
antennas, modifications, or attachments could damage the phone and may
violate FCC regulations.
 NORMAL POSITION:
 Hold the phone as you would any other telephone with the antenna pointed
up and over your shoulder.
 RF Exposure Information:
 This product is compliance to FCC RF Exposure requirements and refers to
FCC websitehttps://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm
search for FCC ID: 2AVB4-LKTABLET to gain further information
 This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions:
 (1) this device may not cause harmful interference, and
 (2) this device must accept any interference received, including
interference that may cause undesired operation.
 NOTE: The manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications to this equipment. Such
modifications could void the user‟s authority to operate the equipment.
 NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
 - Reorient or relocate the receiving antenna.
 - Increase the separation between the equipment and receiver.
 -Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.