Installation & Assembly

ManualsBrandsLoon Peak ManualsCeiling LightsCapitola Simple Bowl Flush Mount

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed. However, the installation

instructions do apply to this product.

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the fuse box or circuit breaker box. Remove the old

fixture from ceiling, including the single bar.

2. Carefully unpack your new fixture and lay out all the parts on a clear area.

Take care not to lose any small parts necessary for installation.

3. Thread the pipe screw part way into the center hole of the single bar and

secure with hex nut.

4. Attach the single bar to the junction box using two box screws as shown. The

side of the single bar marked “GND” must face out . The junction box is

not included.

5. Hold the pan(A) towards the single bar and connect the electrical wires as

follows (See Fig.2). Connect the black wire from the fixture to the black

house (hot) wire; connect the white wire from the fixture to the white house

(neutral) wire. Make sure all wire nuts are secured. You may wrap the

connections with electrical tape. If your Junction box has a ground wire

(green or bare copper) connects fixture’s ground wire to it. Otherwise

attach the bare copper fixture wire to the green ground screw on the single

bar. Tuck the wire connections neatly into the ceiling junction box as you

are holding the fixture assembly toward the ceiling.

6. Raise plate(A) onto the junction box, aligning pipe screw on single bar with

center hole in plate and lock it securely with the ball nut(B).

7. Install the light bulbs(Not included) in accordance with the fixture’s

specifications.

DO NOT EXCEED THE MAXIMUM WATTAGE RATING!

8. Attach the glass shade(C) to the crown(E), raise the assembly to the pan,

aligning the thread hole of pan with the crown's hole, then tighten it with

the screws(D).

Your installation is now complete. Return power to the

unction box and test the fixture.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

FIG.2

FIG.1