Installation & Assembly

Step 3
Step 4
THIS PICTURE SHOWS THE CHAIR BACK STAYS AGAINST THE GROUND
and THE FRONT LEGS HORIZONTAL IN MIDAIR.
WARNING!! DO NOT OVER TIGHTEN. OVER TIGHTENING COULD LEAD TO
DAMAGE OF THE PRODUCT.
TIGHTEN ONLY UNTIL SECURE AND STABLE.
Place the Dining Chair on a Level Surface to see if it wobbles.
If it wobbles, lift the dining chair some 30cm to 50cm high from the ground.
Keep your feet and toes well away from the drop zone.
Drop the Chair freely and vertically with all four legs, hitting the ground, at the
same time.
This Drop Test will help to ensure that all Bolts, and gaps reach full alignment
status.
Test again for evenness on a Level Surface.
If no wobbles are found, proceed to tighten all the Bolts.
Note: When tightening the Bolts, tighten sequentially. Do not tighten any Bolt or
fully and then move towards the next one. This could cause the frame to warp.
If there are still wobbles, loosen the Bolts and execute this same drop test.
Note: If the dining chair is not stable, it could lead to damage to the product.
Place the Seat Base Cover back as shown in picture.
Smooth the Magic Tape down with your hand on all four sides at the edge of the
seat.
Make sure all parts are connected and securely locked into position.
Then stang the Dining Chair up.
Your Dining Chair is ready for use.
This Dining Chair can only be used on a flat, level surface.
① If wobble
③Test again