User's Manual

WPS information contain authentication type, encryption type, config methods, device password
id, selected registrar, state, version, AP setup locked, UUID-E and RF bands as Figure 2-3-1-3.
The introduction indicates as follow :
Authentication Type : There are three type of authentication modes supported by
RaConfig. They are open, Shared, WPA-PSK and WPA system.
Encryption Type : For open and shared authentication mode, the selection of encryption type
are None and WEP. For WPA, WPA2, WPA-PSK and WPA2-PSK authentication mode, the
encryption type supports both TKIP and AES.
Config Methods : Correspond to the methods the AP supports as an Enrollee for adding external
Registrars. (a bitwise OR of values)
Value Hardware Interface
0x0001 USBA (Flash Drive)
0x0002 Ethernet
0x0004 Label
0x0008 Display
0x0010 External NFC Token
0x0020 Integrated NFC Token
0x0040 NFC Interface
0x0080 Push Button
0x0100 Keypad
Device Password ID : Indicate the method or identifies the specific password that the selected
Registrar intends to use. AP in PBC mode must indicate 0x0004 within two-minute Walk Time.
Value Description
0x0000 Default (PIN)
0x0001 User-specified
0x0002 Rekey
0x0003 Display
0x0004 PushButton (PBC)
0x0005 Registrar-specified
0x0006-0x000F Reserved
Selected Registrar : Indicate if the user has recently activated a Registrar to add an
Enrollee. The values are "TRUE" and "FALSE".
State : The current configuration state on AP. The values are "Unconfigured" and
"Configured".
Version : WPS specified version.
AP Setup Locked : Indicate if AP has entered a setup locked state.
UUID-E : The universally unique identifier (UUID) element generated by the Enrollee. There is a
value. It is 16 bytes.
RF Bands : Indicate all RF bands available on the AP. A dual-band AP must provide it. The
values are "2.4GHz" and "5GHz".
- 38 -