User's Manual

Example to Add to Registrar Using PBC Method
The PBC method requires the user to press a PBC button on both the Enrollee and the
Registrar within a two-minute interval called the Walk Time. If only one Registrar in PBC
mode, which PBC mode is obtained from ID 0x0004, is found after a complete scan, the
Enrollee can immediately begin running the Registration Protocol.
If the Enrollee discovers more than one Registrar in PBC mode, it MUST abort its connection attempt
at this scan and continue searching until two-minute timeout.
*Before you press PBC on STA and candidate AP. Make sure all of APs aren't PBC mode
or APs using PBC mode have left their Walk Time.
Go to the box of Config Mode and select Enrollee.
- 69 -