User's Manual

Auth.

Encry.

Setting

WEP/TKIP/AES

Auth. \ Encry. Setting, shown as Figure 3-1.

Figure 3-1 Auth. \ Encry. Setting

Authentication Type : There are 7 type of authentication modes supported by RaUI. They are open,

Shared, LEAP, WPA and WPA-PSK, WPA2 and WPA2-PSK.

Encryption Type : For open and shared authentication mode, the selection of encryption type are

None and WEP. For WPA, WPA2, WPA-PSK and WPA2-PSK authentication mode, the encryption

type supports both TKIP and AES.

- 78 -

8021X : This is introduced in the topic of Section 3-2.

WPA Pre-shared Key : This is the shared secret between AP and STA. For WPA-PSK and

WPA2-PSK authentication mode, this field must be filled with character longer than 8 and less than

32 length.

WEP Key : Only valid when using WEP encryption algorithm. The key must matched

AP's key. There are several formats to enter the keys.

Hexadecimal - 40bits : 10 Hex characters.

Hexadecimal - 128bits : 32Hex characters.

ASCII - 40bits : 5 ASCII characters.

ASCII - 128bits : 13 ASCII characters.