User's Manual

Utility Config
-43-
Wireless mode: Select wireless mode. 2.4G, 5G and 2.4+5G are supported.
Wireless Protection: Users can choose from Auto, On, and Off. (This is not
supported by 802.11n adapters.)
Auto: STA will dynamically change as AP announcement.
On: The frames are always sent with protection.
Off: The frames are always sent without protection.
TX Rate: Manually select the transfer rate. The default setting is auto. (802.11n
wireless cards do not allow the user to select the TX Rate.)
Enable TX Burst: Ralink's proprietary frame burst mode.
Enable TCP Window Size: Optimise the TCP window size to allow for greater
throughput.
Fast Roaming at-: enables fast roaming, which is set by the transmit power.
Select Your Country Region Code: There are eight countries to choose from in the
country channel list.
Show Authentication Status Dialog: When you connect to an AP with
authentication, choose whether show the "Authentication Status Dialog" or not. The
Authentication Status Dialog displays the processes during 802.1x authentication.
Enable CCX (Cisco Compatible Extensions): Choose whether Cisco Compatible
Extensions are supported or not.
LEAP turn on CCKM.
Enable Radio Measurement: can measure the channel every 0~2000
milliseconds.
Apply the above changes.
Icons and buttons:
: Show the Status Section information.
: Hide the Status Section information.
4.2.5 Statistics
4.2.5.1 Statistics
The Statistics page displays detailed counter information based on 802.11 MIB
counters. This page translates that MIB counters into a format easier for the user to