User's Manual

Utility Config
-63-
When errors occur within two minutes of connecting, the WPS status bar might
report "WPS Eap process failed".
Error messages might be:
1. Receive EAP with wrong NONCE.
2. Receive EAP without integrity.
3. Error PIN Code.
4. An inappropriate EAP-FAIL received.
4.2.7.4 Example to Add to Registrar Using PBC Method
The PBC method requires the user to press a PBC button on both the Enrollee and
the Registrar within a two-minute interval called the Walk Time. If there is only one
Registrar in PBC mode, the PBC mode selected is obtained from ID 0x0004, and is
found after a complete scan. The Enrollee can then immediately begin running the
Registration Protocol.
If the Enrollee discovers more than one Registrar in PBC mode, it MUST abort its
connection attempt at this scan and continue searching until the two-minute timeout.
*Before you press PBC on STA and candidate AP. Make sure all APs aren't PBC
mode or APs using PBC mode have left their Walk Time.
Select "Enrollee" from the Config Mode drop-down list.