User's Manual

Connected network:
When RaUI first runs, it will select the best AP to connect to automatically.
If the user wants to use another AP, they can click "Connect" for the intended AP to make a
connection.
If the intended network uses encryption other than "Not Use," RaUI will bring up the security page
and let the user input the appropriate information to make the connection. Please refer to the
example on how to fill in the security information.
When you double click an AP, you can see detailed information about that AP.
The detailed AP information is divided into three parts. They are General, WPS, CCX information and
802.11n (The 802.11n button only exists for APs supporting N mode.) The introduction is as follows:
General information contains the AP#s SSID, MAC address, authentication type, encryption type,
channel, network type, beacon interval, signal strength and supported rates. It is shown in Figure
2-3-1-2.
24