User's Manual

Config Mode: The station serving as an Enrollee or an external Registrar.

Table of Credentials: Displays all credentials obtained by the Registrar. The detailed list includes

information about the SSID, MAC Address, Authentication and Encryption Type. If STA is the

Enrollee, the credentials are created immediately with each WPS success. If STA is the Registrar,

RaUI creates a new credential withWPA2-PSK/AES/64Hex-Key and doesn't change this until

switching to STA Registrar.

Control items for credentials.

1. Detail: Command to obtain Information about Security and the Key in the credential.

2. Connect: Command to connect to the selected network inside credentials. The active selected

credential is as like as the active selected Profile.

3. Rotate: Command to rotate to connect to the next network inside credentials.

4. Disconnect: Stops the WPS action and disconnects the active link. It then selects the most recent

profile on the Profile Page of RaUI. If there are no profiles, the driver will select any non-security AP.

5. Export Profile: Exports all credentials to a Profile.

6. Delete: Deletes an existing credential. And then selects the next credential. If there is not another

credential, the driver will select any non-security AP.

PIN: Start to add to Registrar using PIN configuration method. If STA Registrar, remember that

enter PIN Code read from your Enrollee before starting PIN.

PBC: Start to add to AP using PBC configuration method.

After the user clicks PIN or PBC, please do not rescan within two-minutes of the connection. If you

want to abort this setup within the interval, restart PIN/PBC or click "Disconnect" to stop WPS action.

WPS associate IE: Sends the association request with WPS IE during the WPS setup. It is optional

for STA.

WPS probe IE: Sends the probe request with WPS IE during WPS setup. It is optional for STA.

Progress Bar: Displays the rate of progress from Start to Connected.

Status Bar: Displays the current WPS Status.

Automatically select the AP: Starts to add to AP by using to select the AP automatically in PIN

method.

**There are examples in section 2-7-3(PIN Enrollee Setup), section 2-7-4(PBC Enrollee Setup) and

section 2-7-5(Registrar Configures and AP)**