User's Manual

Describe "WPS Status Bar" - "PIN - xxx" as follow:

Acceptable PIN Configurations:

Start PIN connection - SSID ~> Begin associating to WPS AP ~> Associated to WPS AP ~> Sending

EAPOL-Start ~> Sending EAP-Rsp (ID) ~> Receive EAP-Req(Start) ~> Sending M1 ~> Received M2

~> (Received M2D ~> Sending EAP-Rsp(ACK)) ~> Sending M3 ~> Received M4 ~> Sending M5 ~>

Received M6 ~>Sending M7 ~> Received M8 ~> Sending EAP-Rsp(Done) ~> Configured ~> WPS

status is disconnected ~> WPS status is connected successfully-SSID

WPS configuration doesn't complete after a two-minute connection:

WPS EAP process failed.

When errors occur within two minutes of connecting, the WPS status bar might report "WPS EAP

process failed".

Error messages might be:

1. Receive EAP with wrong NONCE.

2. Receive EAP without integrity.

3. Error PIN Code.

4. An inappropriate EAP-FAIL received.

4.2.7.4Example to Add to Registrar Using PBC Method

The PBC method requires the user to press a PBC button on both the Enrollee and the Registrar within

a two-minute interval called the Walk Time. If there is only one Registrar in PBC mode, the PBC mode

selected is obtained from ID 0x0004, and is found after a complete scan. The Enrollee can then

immediately begin running the Registration Protocol.

If the Enrollee discovers more than one Registrar in PBC mode, it MUST abort its connection attempt

at this scan and continue searching until the two-minute timeout.

*Before you press PBC on STA and candidate AP. Make sure all APs aren't PBC mode or APs using

PBC mode have left their Walk Time.

1. Select "Enrollee from the Config Mode drop-down list.