User's Manual

Start PIN or PBC. The following procedures are as similar as section 2-7-3 (PIN Enrollee Setup) or

section 2-7-4(PBC Enrollee Setup)

If your AP Enrollee has been configured before the WPS process, the credential you set in advance will

be updated to the AP itself. Otherwise, after a successful registration, the AP Enrollee will be

re-configured with the new parameters, and the STA Registrar will connect to the AP Enrollee with

these new parameters.

Describe "WPS Status Bar" - "PIN - xxx" as follow:

A successful PIN Configuration:

Start PIN connection - SSID ~> Begin associating to WPS AP ~> Associated to WPS AP ~> Sending

EAPOL-Start ~> Sending EAP-Rsp (ID) ~> Receive M1 ~> Sending M2 ~> Receive M3 ~> Sending

M4 ~> Receive M5 ~> Sending M6 ~> Receive M7 ~> Sending M8 ~> Receive EAP Rsp (Done) ~>

Sending EAP Rsp (ACK) ~> Configured ~> WPS status is disconnected ~> WPS status is connected

successfully-SSID

Describe "WPS Status Bar" -"PBC - xxx" as follow:

A successful PBC Configuration:

Start PBC connection ~> Scanning AP ~> Begin associating to WPS AP ~> Associated to WPS AP ~>

Sending EAPOL-Start ~> Sending EAP-Rsp (ID) ~> Receive M1 ~> Sending M2 ~> Receive M3 ~>

Sending M4 ~> Receive M5 ~> Sending M6 ~> Receive M7 ~> Sending M8 ~> Receive EAP Rsp

(Done) ~> Sending EAP Rsp (ACK) ~> Configured ~> WPS status is disconnected ~> WPS status is

connected successfully-SSID

4.2.8 About

Click "About" displays the wireless card and driver version information as shown in Figure 2-8.