User's Manual

User Manual
(L-WP-05A5-V2)
Please read over carefully and keep this manual for your
records
Thank you for choosing our Magnetic wireless Power Bank
Product Introduction Wireless Charging the phone
Standard accessories
Wireless Charging area
Specifications
User Manual
Devices built-in wireless charging receiver and support fast
wireless charging
(Galaxy S9 Plus/S10/S10 Plus/Note 10/Note 10 Plus, Huawei
P30 Pro/Mate30/Mate30 Pro/P40 Pro stand charger for
Iphone XS Max/Xr/11/11 Pro/11 Pro Max and all Qi-enabled
devices)
Wireless applicable device
Magnetic charging equipment
(Iphone 12mini/12/12Pro/12Pro Max)
put the device on the middle of the phone back, it can be
adsorbed automatically and charging the phone at the
same time
Magnetic
Wireless Power Bank
ON/OFF
Wireless indicator
Type-C In/Output
Battery indicator
Charging the device
1. Connecting the Type-C interface of the Magnetic wireless
Power Bank to the power adapter
For a better charging experience, please use a power
adapter above 20W
Type-C Input
Type-C Output
Wired Charging the phone
Model No.: L-WP-05A5-V2
120
108×70×8mm
Capacity:
Type-C Input:
Type-C Output:
Wireless Output:
5V3A,9V2.2A,12V2.0A
5V2.4A,9V1.1A,12V1.0A
Magnetic
Wireless Power Bank
USB to Type-C cable
2.The Battery indicator glow white in charging mode ,the
wireless indicator lights up for 5S and then goes out
, the wireless indicator glow blue
Use the charging cable to connect the magnetic wireless
power bank and your phone
≥75%
≤3-6mm
5000mAh/
3.85V/19.25Wh
5W，7.5W，
FCC ID：2AYA9L-L-WP-05A5-V2
NOTE: This equipment has been tested and found to comply with
the limits for aClass B digital device, pursuant to part 15 of the FCC
Rules. These limits aredesigned to provide reasonable protection
against harmful interference in aresidential installation.
This equipment generates uses and can radiate radiofrequency
energy and, if not installed and used in accordance with the
instructions,may cause harmful interference to radio
communications. However, there is noguarantee that interference
will not occur in a particular installation. If thisequipment does
cause harmful interference to radio or television reception,
whichcan be determined by turning the equipment off and on, the
user is encouraged totry to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from
that to which thereceiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Type-c and wireless charger output are not supported at
same time
Changes or modifications not expressly approved by the party
responsible for compliancecould void the user's authority to
operate the equipment.
This device complies with Part15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may
cause undesired operation.
RF Exposure Warning Statements:
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment shall be
installed and operated with minimum distance 20cm between
the radiator & body.