User manual

Start-up
- 44 - 01.10
Characeristic connection13.4
The characteristic selection knob 65 and 
the corresponding table are in the wire
feed casing.
Characteristic tableAbb. 17:
The table content may differ from
your welding machine. The cha-
racteristic lines are set individually
for each machine type.
Select the required material-wire-gas Â
combination from the characteristic table.
Read the corresponding characteristic Â
number off from the right hand column.
65
Characteristic selection knobAbb. 18:
Set the corresponding number from the Â
table using selection knob 65.
Below the characteristic number 0 (ma- 
nual mode)
is the material-wire-gas combination –
nullied. Wire feed and welding volta-
ge can be set manually.
the welding step (Basic Plus) instead –
of material thickness will be displa-
yed.
the must-value for welding voltage –
(Control Pro) instead of material thic-
kness will be displayed.
If an unassigned number is set with
the characteristic selection knob
65, the 7-segment-display 47 will
display the error message „noP“.
i
i