User's Manual
Table Of Contents
- Welcome
- Supported Firmware and Software Versions
- Guide to Relevant Documents
- Overview
- Installation
- Starter Kits, Modules and Options
- Common Terms
- Operation
- Single Ended Input Channel
- Temperature Sensor
- Terminal Strip
- Radio and Antenna
- Node Addressing
- Sample Duration Calculations
- Time Stamping
- Power
- Power Profile
- Operating Temperature
- Sampling Rates
- Datalogging Memory
- Factory Calibration and Testing
- General Specifications
- Mechanical Drawing
- Electrical Block Diagram
- Software
- FCC (United States) Certification
- IC (Industry Canada) Certification
- Support
- Terms and Conditions
- Appendix 1: Host-to-Base Station Communication
- Appendix 2: Datalogging with Agile-Link™ software
- Appendix 3: Streaming with Agile-Link™ software
- Appendix 4: Low Duty Cycle with Agile-Link™ software
- Appendix 5: High Speed Streaming with High Speed Streaming s
- Appendix 6: Bridge Completion Resistors
MicroStrain, Inc.
Temperature Sensor
General Information
• The SG-Link® OEM has an on-board, solid state temperature sensor mounted on
the surface of the circuit board.
• Specifications for this National Semiconductor Model LM60 sensor may be found
at:
http://www.national.com/mpf/LM/LM60.html
• The temperature sensor output is presented on channel 3 of the SG-Link®.
• The temperature sensor has a measurement range of -25˚C to +70˚C range,
accuracy ± 0.5˚C (@25˚ C).
In use with Agile-Link™ software
The SG-Link® OEM temperature sensor outputs 6.25 mV/°C. The Agile-Link™
software uses and any other application should use this formula to calculate temperature:
[]
[]
[]
[]
⎥
⎦
⎤
⎢
⎣
⎡
°
−
⎭
⎬
⎫
⎩
⎨
⎧
⎟
⎟
⎠
⎞
⎜
⎜
⎝
⎛
×
=°
C
mV
mV
Bits
mV
BitsOut
CTemp
25.6
424
4096
3000
27