User's Manual
Table Of Contents
- Welcome
- Supported Firmware and Software Versions
- Guide to Relevant Documents
- Overview
- Installation
- Starter Kits, Modules and Options
- Common Terms
- Operation
- Single Ended Input Channel
- Temperature Sensor
- Terminal Strip
- Radio and Antenna
- Node Addressing
- Sample Duration Calculations
- Time Stamping
- Power
- Power Profile
- Operating Temperature
- Sampling Rates
- Datalogging Memory
- Factory Calibration and Testing
- General Specifications
- Mechanical Drawing
- Electrical Block Diagram
- Software
- FCC (United States) Certification
- IC (Industry Canada) Certification
- Support
- Terms and Conditions
- Appendix 1: Host-to-Base Station Communication
- Appendix 2: Datalogging with Agile-Link™ software
- Appendix 3: Streaming with Agile-Link™ software
- Appendix 4: Low Duty Cycle with Agile-Link™ software
- Appendix 5: High Speed Streaming with High Speed Streaming s
- Appendix 6: Bridge Completion Resistors
MicroStrain, Inc.
Electrical Block Diagram
12 Bit A/D
Temperature Sensor
EEPROM: Sensor Cal. Coeff., Filter
Parameters, 16 Bit ID
Microprocessor with Embedded
Software Algorithms
2 MBytes Flash Memory
Serial (SPI)
2.4 GHz RF Transceiver
2.4 GHz RF Transceiver
Host for Programming,
Display &
Data Acquisition
Analog Base Station
2.4 GHz RF Transceiver
USB Base Station
2.4 GHz RF Transceiver
Serial Base Station
DAQ
USB
USB or RS-232
RS-232
Anti-aliasing Filter
PGA
Instrumentation Amp
0-3 Volts or 0-5 Volts
GND
+3 Volts (regulated)
Differential
Input*
Notes:
*Optional on-board bridge completion
Single
Ended
Input
Offset
Figure 9
44