User's Manual
Table Of Contents
- Welcome
- Supported Firmware and Software Versions
- Guide to Relevant Documents
- Overview
- Installation
- Starter Kits, Modules and Options
- Common Terms
- Operation
- Single Ended Input Channel
- Temperature Sensor
- Terminal Strip
- Radio and Antenna
- Node Addressing
- Sample Duration Calculations
- Time Stamping
- Power
- Power Profile
- Operating Temperature
- Sampling Rates
- Datalogging Memory
- Factory Calibration and Testing
- General Specifications
- Mechanical Drawing
- Electrical Block Diagram
- Software
- FCC (United States) Certification
- IC (Industry Canada) Certification
- Support
- Terms and Conditions
- Appendix 1: Host-to-Base Station Communication
- Appendix 2: Datalogging with Agile-Link™ software
- Appendix 3: Streaming with Agile-Link™ software
- Appendix 4: Low Duty Cycle with Agile-Link™ software
- Appendix 5: High Speed Streaming with High Speed Streaming s
- Appendix 6: Bridge Completion Resistors
MicroStrain, Inc.
Operating up to 4 nodes in streaming mode (broadcast method)
• Establish communication with up to 4 nodes, each paired with a separate base
station and each pair on a different frequency.
• Configure each node individually for a streaming session as described in the
Operating one node in streaming mode section above. Normally all nodes would
be set to the same sweep rate, channel actions, etc. for any given session but there
is no requirement to do this.
• Hold down the SHIFT key and click each node once to highlight it.
• Release the SHIFT key. Make sure that only nodes are highlighted; not base
stations.
• Right-click on any of the highlighted nodes and a drop-down menu appears.
• Click Stream and the nodes will begin streaming data to separate graphs.
• When the streaming ends, move your mouse pointer within the black area of each
Real-time Graph. Right-click and a pop-up menu will appear.
• Click Save Stream. A Save As dialog box appears. Accept or modify the File
Name for the CSV file that will be saved. Click Save. The dialog box will
disappear. This indicates that the streaming data was successfully saved to file on
your PC. Do the same for each node/graph.
63