User's Manual

3. Connect to Nodes
The node can be connected with the automatic node discovery feature and by
manually entering the node address and then searching for it on the current
gateway communication frequency.
1. If the base and node are on the same operating frequency, the node
will populate below the Base Station listing when powering on the
G-Link-200.
Figure 4 - Automatic Node Discovery
2. If a red circle with a number appears next to Base Station, the node
is operating on a separate radio channel. Select the Base Station
and then select the Nodes on Other Frequencies tile.
Figure 5 - Nodes On Other Frequencies
3. Highlight the new node being added. Select Move Node to
Frequency (#).
Figure 6 - Move Node
4. When manually entering the node address, select Manual Add
Node, enter Node Address, last known Frequency (factory default is
15), and select Add Node.
Figure 7 - Adding a Node by Address
3
G-Link-200 Wireless Accelerometer Node QuickStart Guide