User's Manual
1. Remove the cap from the G-Link-200.
2. Remove the three ½ AA batteries from the G-Link-200.
3. Insert three new ½ AA batteries (Saft LS14250 recommended),
observing the correct polarity orientation. The positive polarities are
indicated on the batteries and the node by a "+" symbol.
4. Replace the cap.
7. Battery Hazards
Lithium batteries contain toxic chemicals that are
harmful to humans and the environment. Disposal is
subject to federal and local laws. Do not discard the
battery or the node in the trash. Follow proper battery
disposal protocol, or contact LORD Sensing Technical
Support for information on extracting the battery or
returning the product for proper recycling and disposal.
8. Regulatory Compliance Information
FCC ID: XJQMSLINK0005
IC ID: 8505A-MSLINK0005
G-Link-200Ruggedized High-Speed Triaxial Accelerometer Node
This device complies with Part 15 of the United States FCC Rules, and Industry Canada’s license-
exempt RSSs. Operation is subject to the following two conditions: 1) This device may not cause
interference, and 2) This device must accept any interference, including interference that may cause
undesired operation of the device. Changes or modifications, including antenna changes not
expressly approved by LORD Corporation could void the user’s authority to operate the equipment.
Cet appareil est conforme à la Partie 15 des Règles de la FCC des États-Unis et aux RSSS exempts
de licence d'Industrie Canada. Le fonctionnement est soumis aux deux conditions suivantes: 1) Cet
appareil ne doit pas causer d'interférences et 2) Cet appareil doit accepter toute interférence, y
compris les interférences pouvant entraîner un fonctionnement indésirable de l'appareil. Les
changements ou modifications, y compris les changements d'antenne non expressément approuvés
par LORD Corporation, pourraient annuler l'autorisation de l'utilisateur d'utiliser l'équipement.
5
G-Link-200 Wireless Accelerometer Node QuickStart Guide