Installation Guide

2 Install Water Control Lever
Determine the direction you would like the handle to face when in the off (down) position.
Generally, when installed in the center of the sink, this would be straight forward and when
installed in the corner of the sink, diagonally across the sink. Center the faucet through the hole
in your sink and then hold faucet body in place. Tighten mounting nut until faucet is secure being
careful not to over tighten and then screw in lock-nut screws for final tightening.
3 Connect Hose
Connect sprayer hose. Attach the weight to the hose at a length suitable to you (The further from
the end you place the weight the longer your reach will be when pulling the hose out for use).
You may move the weight to adjust the pull-out length of the hose. Carefully tighten the weight.
!
!
!
!
!
!
!
!
3/6 4/6
INSTALLATION!OF!THE!FAUCET
Before starting turn off both the hot and cold water supply lines and remove the old faucet. Clean
around all areas of attachment before placing new faucet on sink to help prevent corrosion after
installation.
Parts List
Screw Lock-nut Washer
Weight Screw Weight
1 Secure Faucet
Place faucet on sink by feeding hoses down through the center hole in sink. Remove the
mounting nut and nylon washer from threaded collar. Note that the black rubber gasket at the
base of the faucet body remains in place as used to create a seal after faucet is installed.
Install faucet through hole in sink. Slide nylon washer up to threaded collar followed by
mounting nut. Thread mounting nut to underside of sink but do not tighten yet.