Installation Guide

Installation instruction Installation instruction
16
15
8.Apply a circle of anti-mold sealing silicone at
the junction between the toilet and the floor.
After the silicone sealant has solidified, plug in
the power and slowly open the angle valve.
Adjust the water pressure to be within 80 PSI
and inspect the seals of all connection points.
1.The components of the smart toilet seat are pre-assembled
and calibrated at the factory. Unauthorized disassembly or
reassembly is strictly prohibited. Please utilize the new hose
assembly provided with the equipment; reusing the old hose
assembly is not recommended. In case of any issues, kindly
reach out to the local distributor or our company's after-sales
service department.
2.All the information within this user manual is based on the
latest product status at the time of printing. Our company
retains the right to make alterations without further notice.
Connection and Installation of Water Hose:
1. Install the new angle valve and connect the braided hose to the angle valve.
2.After plugging in the power, adjust the angle valve to control the water
pressure to be below 7.5kg.
When replacing the old angle
valve, ensure to install the angle
valve provided with this product.
Old Angle Valve
New Angle Valve
Note: The hose must not be folded,
as this may lead to insufficient water
pressure and render the machine
inoperable.
Inlet Water
Angle Valve
Braided Hose
3. Place a flange ring underneath the toilet.
4.Install the toilet onto the flange plate,
ensuring that the screw mounting holes
align with the holes on the toilet.
5.Sequentially place plastic
washers, gaskets, and screws
onto the toilet mounting holes.
Use a Phillips screwdriver to
tighten the screws on both sides.
Once tightened, cover the screws
with plastic screw caps.
Plastic
Screw Cap
Screw
Washer
P l a st i c
Washer
6. Install the toilet seat onto the toilet body.
Align the toilet seat's positioning holes with the
ceramic body's positioning pins. Press the back
part of the toilet seat firmly with both hands in
a horizontal position, ensuring that the
positioning holes are completely secured onto
the ceramic pins
7.Install the water inlet angle valve and connect
the braided hose (before connecting the braided
hose, please let the water out of the pipe for 3-5
minutes to ensure pipe cleanliness and prevent
the inlet valve from being blocked).
Inlet Water Angle Valve
Braided Hose
Flange Ring
Sewage Outlet
WARN