Installation Guide

Step1: Remove the remote control from the hanger
Step2: Open the battery cover and insert two batteries
Step3: Mount the remote control in the hanger, make sure there is no article cover on
the remote control.
Notes: Use dry cell, alkaline batteries. Follow the instructions below to prevent the
batteries from rupturing or leaking fluid.
● When replacing the batteries, use new batteries of the same brand.
● If you will not be using the remote control for a long time, remove the batteries.
● Do not use rechargeable batteries.
● Resetting the smart toilet after change the batteries.
Turn on the power
Insert the power plug into the socket, and make sure the power indicator lamp on the
power plug turns on.
Open the shutoff valve
Fully open the water shutoff valve.
Make sure the indicator lamp lighting
● Make sure the toilet power indicator lamp is on, if not, press the button on the
leakage protection plug to turn the power on.
● Make sure the water temperature indicator lamp is on, if not, press the remote control
" WATER " button.
● Make sure the seat temperature indicator lamp is on, if not, press the remote control
" SEAT " button.
Preparation For the Pirst Time Use
Install the remote control battery
18
17
Installation instruction
Note: This product utilizes an advanced cyclonic
siphonic jet flushing technology. In areas with
higher water pressure (exceeding 3 kilograms
of pressure), there might be a slight occurrence
of splashing and jet noise during the cyclonic flush
on the ceramic surfaces. If this issue is pronounced
, you can gradually adjust the angle valve to the
right to reduce water pressure, ensuring that the
flushing function operates smoothly.
Attention:
In the event of a power outage during the cleaning
process, please close the angle valve to stop the
water supply. Once power is restored, the functions
will undergo a self-check and return to normal
operation.
Adjust the angle valve
Decrease
Increase
Close the angle valve
Close
Open