Installation Guide

Table Of Contents

●Maintenance

1. Nozzle clean

For the Side Control Knob Version:

When the product is standby, turn and hold the side control knob to female wash

for 3 seconds until the beeps to activate cleaning wand coming out. Then use a

toothbrush to clean the nozzle.

For the Side Control Panel Version:

When the product is standby, press and hold the female wash button for 3 seconds

until the beeps to activate cleaning wand coming out. Then use a toothbrush to clean

the nozzle.

Maintenance and Cleaning

Clean the filter(When the flushing system doesn’t function well)

1、Close water shutoff valve to stop the water supply.

2、Remove the filter by coin.

3、Clean the filter:

● To clean the filter by running water after disassemble it.

● To remove any residue by toothbrush.

4、Install the filter back:

● Tightly assemble the filter, and open the water shutoff valve to check if any

leakage.

5、Open the water shutoff valve to work.

1.Close the water shutoff valve

Filter

3.Clean the dirty

2.Gently remove the filter

Water Shutoff

Valve

Small Basin

Close it

Counterclockwise

remove the fileter

Maintenance and Cleaning

Cap

Filter

Pipe

To prevent product damage, please do as following:

• Always test your cleaning solution on an inconspicuous area before applying to

the entire surface.

• Wipe surfaces clean and rinse completely with water immediately after applying

cleaner. Rinse and dry any over spray that lands on nearby surfaces.

• Do not allow cleaners to soak on surfaces.

• Use a soft, dampened sponge or cloth. Never use an abrasive material such as a

brush or scouring pad to clean surfaces.