Installation Guide

14
13
Installation instruction Installation instruction
Required Tools:
Screwdriver
Wrench Marker
Tape measure
Caulking gun
Electric drill
Installation Diagram::
400±10mm
Socket/
Outlet
Inlet Water
Angle Valve
Floor
Drainage Hole
Centerline
Pre-Installation Precautions:
1.Water Pressure Test: Ensure that water flow
exceeds 1.32 gallons within 15 seconds.
2.Prior to installation, run hot water through the
pipes for 2 minutes and then connect them to the inlet
water pipe before proceeding with the installation.
Installation Steps:
145mm
图（1）
1.For a newly installed toilet in the bathroom, a flange plate needs to be
added.(Purchase flange plates by oneself)
● Place the flange plate into the drainage hole, aligning the arrow on
the flange plate with the dashed line on the vertical wall.
● Use a marker to indicate the positions of the four installation holes on
the flange plate.
● On the dashed line of the horizontal wall, mark the positions of the two
floor anchor screw holes with a marker. Refer to arrow in Figure (2) for
the indicated positions. The distance between the centers of the two
holes is 145mm.
● Use an electric drill to create four Φ6mm installation holes on the
flange plate. Insert four corresponding plastic anchors.
● Use an electric drill to create two Φ10mm installation holes at the
marked positions for the floor anchor screws. Insert two corresponding
plastic anchors.
● Secure the flange plate in place using the provided four screws.
Ceramic as shown in Figure (1) Figure (2)
Drainage Hole
12 inches(305mm)
2. Lift the toilet seat from the toilet.
Note: When lifting the toilet seat, lift it
from the inside and avoid pulling it too
forcefully.
Power Outlet Installation Instructions:
1.Please ensure that the selected power outlet has been
properly grounded according to the appropriate protocols.
2.l The power cord should have a length of 1.5 meters. The
positioning of the power outlet should be in close proximity to
facilitate the installation and disassembly of this product, while
also maintaining a considerable distance from the bathtub area.
3.It is strongly recommended to opt for a waterproof-type outlet.
Avoid the use of extension cords to connect the product.
Failure to comply with these directives could potentially result
in fire hazardsor electrical shock.
Uplift
Toilet cover
WARN